Pulnix TS-9720EN Series Manuel d'instructions télécharger pdf (Page 22)

Page 12

Installation and Operation

VIS 300/400 EN Setup Software

2.5.3 (a) Context menus

Right-side clicking the mouse on the camera-tree side of the C

AMERA PROPERTIES window activates the

context menus.

The menu is shown in Figure 2.14 and applies for the camera(s) selected.

FIGURE 14. Camera Properties Context Menu

2.5.3 (b) =>Search for Cameras

This command starts a new search for cameras on the local network. The message box below is shown

when ENSetup opens the connections.

FIGURE 15. Search for Cameras Message Box

If any IP-address problems are detected then a window will be displayed and it will be possible to

correct these problems (see appendix C for description on how to correct IP-address problems).

2.5.3 (c) =>Open Cameras

This command opens a specific camera by specifying an IP-address. This can be used, if the camera is

not on a local subnet and therefore not found automatically during a search (Section 2.3 on page 4 or

Section 2.4 on page 4).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Pas de commentaire

Pulnix TS-9720EN Series Manuel d'instructions Page 22