Pulnix TMC-6700 Series Manuel d'instructions télécharger pdf (Page 32)

Page 24

TMC-6700/1000 Series RS-232C Control

TMC-6700/1000 Series Progressive Scan CCD Digital Color Camera

D3 Rear Panel Override Flag

D2:0 Ram Bank Number -1 (0, 1, 2 or 3)

D3 is the rear panel override flag, indicating whether the software or the rear panel

has priority regarding parameter control.

Note: Once any rear panel switch is changed, rear panel control will take priority, and the

configuration of all the rear panel switch settings will apply to the current image:

4.2.3 Save RAM Data Into EEPROM

Function: Save all four RAM data banks into EEPROM.

All of the data in the four RAM banks can be saved into EEPROM by sending the

following command code:

TX Command Code

MSB LSB

76543210

10001010

4.2.4 Load RAM Data From EEPROM

Function: Load config data from EEPROM to all four RAM banks.

Data saved in EEPROM can be loaded from EEPROM into four RAM banks by

sending the following command code:

TX Command Code

MSB LSB

76543210

11000000

4.2.5 Write 1 Byte Into RAM Bank

Function: Write 1 byte of data into the location of a specific address in a RAM bank.

After the RAM bank is selected, new 8-bit data can be written to the desired location

of a specific address by sending the following command code:

TX Command Code 1

MSB LSB

76543210

0 1 A5A4A3A2A1A0

A5:0 RAM address

TX Command Code 2

MSB LSB

76543210

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Pas de commentaire

Pulnix TMC-6700 Series Manuel d'instructions Page 32