Pulnix TMC-4200CL Manuel d'instructions télécharger pdf (Page 16)

Page 4

TM/RM/TMC/RMC-4200GE Software

Software Introduction

3. Click the Change or Remove button as shown in Figure 3 on page 4.

FIGURE 3. Change and Remove Buttons

1.4.4 Quick-Start

Use the following quick-start process when the Camera Interface Application is installed on your PC.

1. Connect the camera. The Hirose pin layout is shown in Table 1 on page 6. Both the Hirose and the

network cable (RJ-45) are illustrated in Figure 6. Verify that both LED’s on the RJ-45 connector

are green.

2. Run the Camera Interface Application.

3. Click Detect. Assign a suitable IP address to the camera. The window shown in Figure 2 appears.

FIGURE 4. Network Device Finder Window

Select the appropriate camera from the list, similar to the window shown in Figure 5 on page 5 and

click OK.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 91 92

Pas de commentaire

Pulnix TMC-4200CL Manuel d'instructions Page 16