Pulnix TMC-4200CL Manuel d'instructions télécharger pdf (Page 46)

Page 34

Dual-Tap TM-4200GE AccuPiXEL Series Camera-Control Software

Introduction

6.1.3 Uninstalling the Software

To uninstall the Cam2Net series camera-control software from the control panel, follow the steps

below.

1. Open “Add or Remove Programs” in the control panel.

2. Select “Cam2Net” from the lists of the installed software.

3. Click the “Change” or “Remove” button.

FIGURE 29. The “Add or Remove Programs” utility can uninstall older software.

6.2 TM/TMC-4200GE Camera

FIGURE 30. Back of the TM-4200GE

The camera must have all cables properly connected and any required adapters installed and configured

to allow the software to perform the operations on the interface.

GigE

POWER

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 91 92

Operation Manual 1
Warranty 3
Certifications 3
Supplement 4
Table of Contents 5
Page vii 7
Page viii 8
List of Figures 10
List of Tables 11
Page xii 12
TM/RM/TMC/RMC-4200GE Software 13
1.4 Software Installation 14
1.4.4 Quick-Start 16
2 Connectors 18
2.2 Ethernet 19
3.1 Setup 20
3.2 Configuring the Imager 22
3.4 Modes 23
FIGURE 13. Exposure Control 24
FIGURE 15. Shutter Speed 25
FIGURE 16. Scan Mode 26
3.4.6 Gain Settings 28
3.4.7 The Gain 28
3.4.8 Look-Up Table 29
3.4.9 Memory Pages 29
3.4.10 Free-Running Mode 30
3.4.11 Externally Triggered 30
3.4.12 Internally Triggered 30
3.4.15 Main Menu: “Option” 32
3.4.16 Version 32
3.4.17 Exit 32
4 Signal Handling 33
FIGURE 24. GPIO Look-Up Table 35
4.4 GPIO Label Table 36
4.5 Pulse Generators 37
TABLE 5. Command Responses 41
Dual-Tap TM-4200GE AccuPiXEL 43
Camera-Control Software 43
6.1 Software Installation 44
6.2 TM/TMC-4200GE Camera 46
FIGURE 31. Main DualTap 47
FIGURE 33 49
6.5.2 Gain Control 51
6.5.3 Offset Voltage 51
Tap Selection: 52
6.5.5 LUT (Look-Up Table) 53
6.5.6 Main Menu: “Option” 55
6.5.7 EEPROM 55
Introduction 56
TM/TMC/RM/RMC-4200GE 57
Hardware 57
7.2 Features 58
8 Installation 59
TABLE 6. 12-Pin Connector 60
External sync input 62
Analog Ch. A only 62
TM/TMC/RM/RMC-4200GE Hardware 63
8.2.5 Adjustable Back-Focus 63
9 Operation 64
FIGURE 53. Bayer 1 66
FIGURE 54. Bayer 2 66
FIGURE 55. 2x2 Binning 67
FIGURE 57. 1x Digital Zoom 68
FIGURE 58. 1.3x Digital Zoom 68
FIGURE 59. 2x Digital Zoom 69
FIGURE 60. 4x Digital Zoom 69
9.2.1 Color Filter Array 70
Last pixel of 1st Line 71
Last pixel 71
Horizontal Shift Registers 71
CCD Output 71
9.2.4 Sync and Data 72
9.2.5 Camera Functions 72
9.2.6 Timing Chart 73
9.3 Electronic Shutter 74
9.3.1 Preset Shutter 75
9.3.7 PWC PIV Mode 79
9.4 Dynamic Range Control 80
9.6 Camera Timing Charts 81
TABLE 10. Video Output 82
TABLE 12. Async Reset 83
10 Troubleshooting 84
11 Appendix 86
FIGURE 75. Spectral Response 89
Appendix 90
www.jai.com 91

Commentaires sur ces manuels

Pas de commentaire

Pulnix TMC-4200CL Manuel d'instructions Page 46

Commentaires sur ces manuels

Produits connexes et manuels pour Caméras de sécurité Pulnix TMC-4200CL