Pulnix TM-7EX Manuel télécharger pdf (Page 13)

1 MVS-8100L Hardware Installation

Cognex MVS-8100L Hardware Manual 13

Figure 5. Location of pin 1 of connector JP3 on MVS-8100L

Caution Failure to match up the red edge of the ribbon cable on the

expansion panel connector with pin 1 on connector JP3 of the

MVS-8100L may result in damage to a camera, the frame grabber,

or both.

7. If you are not using the trigger and strobe expansion panel, proceed to the next

step. If you are using the trigger and strobe expansion panel, Cognex P/N

800-0062, install it in an unused slot position. Connect the ribbon cable to

connector JP4 on the MVS-8100L so that pin1 on both connectors are aligned as

shown in Figure 6 and Figure 7.

Figure 6. Trigger and strobe expansion panel (P/N 800-0062)

Pin 1

JP3

Pin 1 on this connector must connect

Pin 1

to pin 1 on connector JP4 on 8100L.

DB-9F connector

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Pas de commentaire

Pulnix TM-7EX Manuel Page 13