Pulnix TM-7EX Manuel télécharger pdf (Page 17)

1 MVS-8100L Hardware Installation

Cognex MVS-8100L Hardware Manual 17

Configuring Sony XC-ST50 Cameras

The MVS-8100L supports the use of the Sony XC-ST50 cameras. If you purchase your

XC-ST50 cameras from Cognex, they arrive ready to use with the MVS-8100L. If you

purchase your XC-ST50 from a third party, you must configure the camera as shown in

this section.

Figure 9 shows the back panel of the Sony XC-ST50 camera with the switches in their

factory default positions.

Figure 9. Sony XC-ST50 camera back panel

To configure the switch for the Sony XC-ST50 camera:

1. Configure the 8-position DIP switch as shown in Figure 9.

Note Set switch 5 to ON in free-running mode to use field integration

rather than frame integration (single field and half-resolution video

formats only).

2. Set gain to the “F” position.

3. Set the INT EXT switch to external (EXT).

4. Set TRIG to +.

5. Set gamma (γ) to off.

6. Set the 75Ω switch to ON.

75Ω

OFF

TRIG

GAIN

VIDEO

OUT

INT

EXT

DC IN

SYNC

OFF

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Pas de commentaire

Pulnix TM-7EX Manuel Page 17