Pulnix TMC-6 Manuel d'instructions télécharger pdf (Page 14)

Page 6

Installation

TM-1402 Series Progressive Scan Shutter Cameras

recommends using a cooling fan to set up a positive air flow around the camera, and following the

precautions below:

• Mount the camera on a large heat sink (camera bracket) made out of a conductive material such as

aluminum.

• Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conducting

material like plastic.

• Make sure the camera has enough open space around it to facilitate the free flow of air.

2.2.2 Connector Pin Configurations

2.2.2 (a) 12-Pin Connector (TM-1402)

FIGURE 3. 12-Pin Connector on Rear Panel of Camera

The TM-1402 has a 12-pin Hirose connector for power input, serial

communication, and signal integration. Pin #1 is Ground and Pin #2 is

+12V DC. Other pins handle a number of input and output functions,

as shown in Table 1 below.

TABLE 1. 12-Pin Connector (TM-1402)

2.2.2 (b) 12-Pin Connector (TM-1402CL)

The TM-1402CL has a 12-pin Hirose connector for power input and signal integration. Pin #1 is Ground

and pin #2 is +12V DC. The pinout table is shown below. For the TM-1402CL, serial communication

camera control is done via the MDR26 Camera Link connector on the rear panel of the camera.

Pin Description Pin Description

1 GND (power) 7 VD In

2 +12V DC 8 Reserved

3 GND (analog) 9 HD In

4 Video Out 10 RXD (RS-232)

5 GND (digital) 11 N/C

6 VINIT In 12 TXD (RS-232)

TABLE 2. 12-Pin Connector (TM-1402CL)

Pin Description Pin Description

1 GND (power) 7 VD in

2 +12V DC 8 Reserved

3 GND (analog) 9 HD in

4 Video out 10 N/C

5 GND (digital) 11 N/C

6 VINIT in 12 N/C

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 44 45

Pas de commentaire

Pulnix TMC-6 Manuel d'instructions Page 14