Pulnix TMC-6DSP Manuel d'instructions télécharger pdf (Page 31)

SOFTWARE INSTRUCTIONS

TMC-7DSP/TMC-6DSP Color CCD Camera Page 25

4.2.10 (b) Writing the Current Setting to EEPROM

The current setting can also be saved by writing the setting to EEPROM. Select “Write” -> “EEPROM”

from the menu bar (below).

The following parameters are not loaded from EEPROM upon booting up. At boot time, the back panel

mode switch controls these parameters.

• Shutter Mode and Shutter Speed

• White Balance

• Gamma

• Back Light Compensation

To read in these saved parameters from EEPROM, select “Read” -> “EEPROM” (Refer to).

4.2.11 Read Setting

Settings saved either on the PC’s hard disk as a text ﬁle or EEPROM can be loaded on the TMC-7DSP/

TMC-6DSP camera.

4.2.11 (a) Read Setting Saved On Hard Disk as a File

TMCDSP allows you to load saved settings. To load the setting, select “File” -> “Open” from the menu

bar.

4.2.11 (b) Read Setting Saved in EEPROM

You can read in the saved setting from EEPROM. Select “Read” -> “EEPROM” from the menu bar.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 40 41

Pas de commentaire

Pulnix TMC-6DSP Manuel d'instructions Page 31