Pulnix TS-9720EN Series Manuel d'installation télécharger pdf (Page 107)

Page 95

VIS CAM 300/400 Installation Manual

Appendix E: Moxa N-Port 5232 Configuration

Serial port 1 settings:

Port alias: D1 – enter desired name of this specific serial port.

Baud rate: 9600

– specify the desired baud rate of the serial port – the TLS200 light

sensor requires 9600 as standard.

Data bits: 8

– specify the desired size of the data bits used - the TLS200 light sensor

requires 8 as standard.

Stop bits: 2

– Specify the desired size of the stop bits used - the TLS200 light sensor

requires 2 as standard.

Parity: None – feature not used in communication with the light sensor.

Flow control: None - feature not used in communication with the light sensor.

Fifo: Enable

- the TLS200 light sensor requires FIFO as standard.

Interface: RS-485 2wire

– the communication with the TLS-300 light sensor is standard

2-wire RS-485.

Enable – apply the above settings to all serial ports – rename port 2 port alias to D0.

FIGURE 89. Standard configuration of Serial settings for port 1:

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 115 116

Pas de commentaire

Pulnix TS-9720EN Series Manuel d'installation Page 107