Pulnix TS-9720EN Series Manuel d'instructions télécharger pdf (Page 23)

TS-9720EN Series Progressive Scan Shutter Cameras

Page 15

Tutorial

3.2 Image Transfer

3.2.1 FTP Image Transfer

To transfer images via FTP, first make sure to set up the FTP server properly. Please check the

following items:

The username/password or anonymous login must be set for FTP server.

Set the permission of the read/write/create directory.

First, type the IP address of the FTP server (destination IP). If you have a second FTP server, enter that

IP address as well. If the EN camera detects that the first FTP server is down, then it will automatically

send images to the second FTP server.

Enter the User name and Password that the FTP server gives permission to.

Type image type (TIF or JPEG). “Image1 Data” is an image triggered by the first TTL trigger, Ethernet

trigger, or RS-485 serial trigger. If the second FPGA trigger is set (Config Address=28), then the FPGA

automatically generates the second hardware trigger predefined delay after the first hardware TTL

trigger. “Image 2 Data” defines image type of the second triggered image. Normally, you should ignore

the “Image 2 Data.”

“Subdirectories” is normally set to 1000. The EN creates subdirectories under a single Destination DIR.

When the number of files in the subdirectory reach 1000, then the EN automatically creates another

subdirectory. Naming conventions of the subdirectory can be found in the LC-to-EN interface

document.

“Destination DIR” is a name of the directory where all “Subdirectories” are located.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 62 63

Pas de commentaire

Pulnix TS-9720EN Series Manuel d'instructions Page 23