Pulnix TS-9720EN Series Manuel d'instructions télécharger pdf (Page 36)

Page 28

Tutorial

TS-9720EN Series Progressive Scan Shutter Cameras

Enter the command “ifconfig eth0 <NEW IP ADDRESS> netmask <SUBNET MASK>.” This is a

temporary IP assignment because the EN camera will lose this setting once you restart it.

Now you should be able to telnet to the EN cameras.

If you want to assign the new IP address permanently, you can use the “test_libcamera” utility. The

“test_libcamera” utility allows access to EEPROM, where all network settings are saved. After starting

“test_libcamera,” you can use the following commands:

rc : read IP assignment (static or dhcp) wc : write IP assignment

rp : read IP addresss wp : write IP address

rs : read Subnet mask ws : write Subnet mask

rg : read Gateway wg : write Gateway

Change the IP assignment/IP address/SubnetMask/Gateway. Reboot the camera. The new IP address/

subnet mask are used at the next power-up.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 62 63

Pas de commentaire

Pulnix TS-9720EN Series Manuel d'instructions Page 36