Pulnix TM-7EX Informations techniques télécharger pdf (Page 11)

OMI 2.3.1 Release Notes

OMI 2.3.1 Release Notes 11

Cameras and Video Formats Supported

This section describes the cameras and video formats that OMI 2.3 supports. Camera

support varies by frame grabber, and, if your frame grabber supports them, by Cognex

Video Module (CVM).

To use this section effectively, look up the frame grabber and CVM you plan to use in

the following sections. Then, refer to the section Video Formats Supported In This

Release on page 20 to find out which video formats you can use.

Caution The tables list the Cognex camera cables required. Cameras must

be connected using the Cognex cables shown in these tables.

Using non-Cognex camera cables could damage your Cognex

hardware, your camera, or both.

Cameras and Camera Lenses

You may purchase cameras for use with your frame grabber through Cognex, or you

may use your own compatible cameras. Consult with your Cognex representative for

cabling and other requirements if you plan to use non-standard cameras. Failing to do

so may affect the warranty coverage on your vision processor.

Cognex offers a lens kit (P/N 800-1000), which includes five lenses (8.5 mm, 12.5 mm,

16 mm, 25 mm, and 50 mm F2.8 macro), a C-mount adapter, and an extension tube set.

Cognex also offers a variety of camera lenses that you can order individually, including

all the lenses in the lens kit, plus 50 mm, 75 mm, and 135 mm lenses. You can also order

a C-mount adapter, a 2X extender lens, or an extension tube set.

In the following tables, the term rapid reset means that the camera resets the sync signal

the instant that a request for an image arrives.

Special Camera Settings

Certain supported cameras require special settings when used with MVS-8000

hardware. All special camera settings are listed in the hardware manual for your frame

grabber.

The cameras that require special settings are:

• Sony XC-55 and XC-55BB

• Sony XC-ST50 and XC-ST50CE in rapid-reset mode

• Pulnix TM-9701

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Pas de commentaire

Pulnix TM-7EX Informations techniques Page 11