Pulnix TM-7EX Manuel télécharger pdf (Page 10)

Installing the MVS-8100C 1

10 Cognex MVS-8100C Hardware Manual

3. Remove the cover of the host PC and select a PCI slot for the MVS-8100C. The

MVS-8100C requires a PCI slot that supports 5 V signalling. The MVS-8100C’s PCI

bus connector is slotted to allow placement only in a 5 V slot (which are the most

commonly found PCI slot types).

Motherboard PCI slots are keyed to allow acceptance of boards that use either 5 V

or 3.3 V signalling, or both. The bus connectors on all PCI boards are slotted to

disallow placement of the board in the wrong type of slot. PCI slot keys are

described in the following table and diagram.

Figure 1. PCI slot types

Caution Failure to properly attach and configure the external power cord to

your MVS-8100C as described in the following steps may result in

damage to your frame grabber, motherboard, or both.

PCI Slot Type Key in PCI Slot

Supports 3.3 volt boards Key is towards the back of the PC

Supports 5 volt boards Key is towards the front of the PC

Table 1. PCI slot types

Back of PC Front of PC

5 volt key

3.3 volt key

5 volt key

64-bit PCI or PCI-X slots

32-bit PCI slots

key

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Pas de commentaire

Pulnix TM-7EX Manuel Page 10