Pulnix TM-7EX Manuel télécharger pdf (Page 17)

1 Installing the MVS-8100C

Cognex MVS-8100C Hardware Manual 17

Connecting Sony XC-003 Color Cameras

Follow these steps to connect a Sony XC-003 to the MVS-8100C, using Cognex camera

cable 300-0243.

1. Use the XC-003 in its default configuration. There is no need to set jumpers or

switches, or to use the XC-003’s menu configuration system to prepare the camera

for use with the MVS-8100C.

2. Power off the PC containing the MVS-8100C. Do not connect cameras or peripheral

equipment to the MVS-8100C when powered on.

3. Connect cable 300-0243’s 15-pin port to camera port 1 or 3 on the MVS-8100C. Do

not connect a color camera to ports 0 or 2.

4. Connect the cable’s round Hirose connector to the XC-003’s DC IN/VBS port.

Figure 7. Rear connections on Sony XC-003 camera

5. Connect the cable’s DB-9 connector to the RGB/SYNC port on the XC-003.

The MVS-8100C supports one or two XC-003 cameras. When using an XC-003, set up

your MVS-8100C for use with color cameras, as shown in Table 2 on page 14.

Configuring Sony XC-55 Cameras

The MVS-8100C supports the use of the Sony XC-55 and XC-55BB cameras. If you

purchase your XC-55 cameras from Cognex, they arrive ready to use with the

MVS-8100C. If you purchase your XC-55 from a third party, you must configure the

camera as shown in this section.

DC IN/VBS

VIDEO OUT

RGB/SYNC

LENS

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Pas de commentaire

Pulnix TM-7EX Manuel Page 17