Pulnix TM-7EX Manuel télécharger pdf (Page 14)

Installing the MVS-8100C 1

14 Cognex MVS-8100C Hardware Manual

Installing Cameras

You can connect from one to four monochrome cameras (EIA or CCIR) or up to two RGB

color cameras. Jumper settings on the MVS-8100C select color or monochrome mode.

You cannot combine color and monochrome cameras at the same time.

When you set the jumpers for color mode, camera ports 0 and 2 are disconnected and

should not be used. Connect color cameras only to camera ports 1 or 3.

Table 2 shows the MVS-8100C’s camera connection options. See Table 21 on page 50

to determine the Cognex cable part number for your camera.

On all vertically-oriented MVS-8100C jumpers, pin 1 is at the top of the board. On all

horizontally-oriented jumpers, pin 1 is at the left of the board. Figure 5 shows the factory

default settings of the color/monochrome selection jumpers.

Figure 5. MVS-8100C jumper orientation

Mode Jumper Pins

Use

camera

ports

Requires

Camera

Expansion

Panel?

One color

camera

JP10 Cover pins 2-3 *

1No

J1 Cover pins 1-2 *

Two color

cameras

JP10, JP11 Cover pins 2-3 *

1 and 3 Yes

J1, J7 Cover pins 1-2 *

One or two

monochrome

cameras

JP10 Cover pins 1-2

0 and 1 No

Sets rapid reset mode.

See Table 3 on page 21.

One to four

monochrome

cameras

JP10, JP11 Cover pins 1-2

0, 1, 2,

and 3

Yes

J1, J7 Sets rapid reset mode.

See Table 3 on page 21.

* Factory default setting

Table 2. MVS-8100C camera connection options

JP11 J7

JP10

123

Top of MVS-8100C

Slot cover with camera and light ports

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Pulnix TM-7EX Manuel Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Caméras de sécurité Pulnix TM-7EX