Pulnix TM-7EX Manuel télécharger pdf (Page 16)

Installing the MVS-8100C 1

16 Cognex MVS-8100C Hardware Manual

4. Connect an NTSC monitor to the camera’s composite video connector labeled

VIDEO OUT.

5. Provide power to the camera through the Hirose connector labeled DC IN/VBS .

Live video now displays on the monitor.

To provide +12 V power to the camera, you can connect the Hirose branch of the

Cognex camera cable from an MVS-8100C in a powered-on PC, or you can provide

power from a bench power supply.

6. Press the MENU button and observe the video monitor. With switch S102 in its

normal up position, the MENU button displays a setup menu. With switch S102 in

the down position, pressing MENU displays numeric registers plus one setup line

of text at the bottom of the screen.

The bottom setup line reads “DSPAdj No. 00 Data 00” This is DSP adjustment

number 00, containing the data value 00.

7. Press the Í and Î buttons at the same time. This resets the setup line to its middle

position, where the DSP adjustment number is 240, and data value is 8C.

8. Press the Î button until the DSP adjustment number is 336. You can hold in the Î

button to fast forward the change in adjustment numbers.

9. At DSP adjustment number 336, press the Ï or Ð buttons as required to change

the data value from 32 to 3C.

10. Press the Í and Î buttons at the same time to return the setup line to DSP

adjustment number 240 and data value 8C.

11. Press the Í button until the DSP adjustment number is 207. Hold the button in to

fast forward.

12. At DSP adjustment number 207, press the Ï or Ð buttons as required to change

the data value from F9 to 40.

13. Carefully slide switch S102 to its up position, labeled OPE. Press the MENU button

to make sure the standard SETUP menu displays, and not the DSPAdj line.

14. Power off the camera by removing the Hirose cable from the DC IN/VBS connector.

Then remove the video out cable, and replace and refasten the top cover on the

DXC-390.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Pas de commentaire

Pulnix TM-7EX Manuel Page 16