Pulnix TM-7EX Manuel télécharger pdf (Page 15)

1 Installing the MVS-8100C

Cognex MVS-8100C Hardware Manual 15

Connecting Pulnix TM-6CN Cameras

The Pulnix TM-6CN camera supplies synchronization signals to the MVS-8100C. The

MVS-8100C needs no special hardware settings when using camera-supplied sync

signals from monochrome cameras. As long as the Cognex vision processing software

is set up to use a Pulnix TM-6CN, the sync signals will be handled correctly. The only

hardware setting required to use the TM-6CN is to set the MVS-8100C for use with

monochrome cameras, as shown in Table 2 on page 14.

Configuring Sony DXC-390 Color Cameras

The MVS-8100C supports the use of the Sony DXC-390 color camera. If you purchase

your DXC-390 camera from Cognex, it arrives ready to use with Cognex software.

Note Sony DXC-390 cameras purchased from Cognex may be labeled

DXC-390/C on the camera body or on the shipping box or both. The

/C designation applies to cameras that have been set up as

described in the following steps.

If you purchase your DXC-390 from a third party, you must configure the camera as

shown in the following steps.

The following procedure expands the effective horizontal imaging area of the DXC-390

by 200 ns per line, and reduces the video noise level.

1. Remove and carefully set aside the seven small screws that fasten the top cover of

the DXC-390. Remove the top cover.

2. Locate switch S102 as shown in Figure 6.

Figure 6. Sony DXC-390 with cover removed

3. Use a small screwdriver to move switch S102 to the down position, labeled ADJ.

S102

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Pas de commentaire

Pulnix TM-7EX Manuel Page 15