Pulnix TM-7EX Manuel télécharger pdf (Page 23)

1 Installing the MVS-8100C

Cognex MVS-8100C Hardware Manual 23

Installing External I/O Equipment

You can connect the following peripheral equipment to the MVS-8100C:

• One to four trigger pulse generators to trigger image acquisitions on monochrome

cameras

• One to four strobe lights to allow MVS-8100C-controlled illumination of the scene

under one to four monochrome cameras

• One status output line that can be used by your vision processing application, for

example, to control a parts reject switch.

• External camera synchronization signals.

• One to four light modules, which allow software-controlled dynamic light adjustment

of the scene under a camera lens.

Trigger and I/O Expansion Panel

To connect trigger, strobe, status, or external sync lines, use the trigger and I/O

expansion panel (P/N 300-0240) included with your MVS-8100C. Secure the expansion

panel to an unused bus slot position on the PC’s back panel. A 25-line ribbon cable

extends from the trigger and I/O expansion panel to the pin block at position J6, in the

upper right corner of the MVS-8100C.

Figure 10. Trigger and I/O expansion panel (P/N 300-0240)

Connect wires from trigger, strobe, or external synchronization equipment to

appropriate positions of the trigger and I/O expansion panel’s DB-25F port, using the

pinout in Table 19 on page 44 as a guide.

Red wire must connect to pin 1

Pin 1

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

Pas de commentaire

Pulnix TM-7EX Manuel Page 23