Pulnix TM-7EX Manuel télécharger pdf (Page 21)

1 Installing the MVS-8100C

Cognex MVS-8100C Hardware Manual 21

Using Rapid Reset Mode

No special hardware settings are required to use an electronically shuttered (rapid

reset) monochrome camera, such as the Sony XC-55, on the MVS-8100C’s camera

ports 0 or 2. However, for camera ports 1 and 3, the factory default configuration is to

support color cameras. To use a rapid reset camera on camera ports 1 or 3, set jumpers

on the MVS-8100C as shown in Table 3.

Using Genlock Mode

In genlock mode, the MVS-8100C synchronizes to the composite sync (CSYNC) signal

from the camera. When a camera runs in this mode, it generates H and V sync signals

and mixes them with the video signal to produce composite video. The MVS-8100C

strips the composite sync signal from the composite video and locks onto it.

No special hardware settings are required to use genlock mode on monochrome

cameras connected to any camera port. However, you must set jumpers on the

MVS-8100C to use genlock mode for color cameras connected to camera ports 1 or 3,

as shown in Table 4.

Note The Sony XC-003 color camera does not support genlock mode.

MVS-8100C

Camera Port Factory Default Setting Rapid Reset (XC-55) Setting

0 None No jumper changes required

1 J1, pins 1-2 covered Cover pins 2-3 on J1

2 None No jumper changes required

3 J7, pins 1-2 covered Cover pins 2-3 on J7

Table 3. Jumper settings for rapid reset mode

MVS-8100C Color

Camera Port Factory Default Setting

Setting for Genlock Mode

for Color Cameras

1 J8, pins 1-2 covered Cover pins 2-3 on J8

3 J13, pins 1-2 covered Cover pins 2-3 on J13

Table 4. Jumper settings for Genlock mode for color cameras

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Pas de commentaire

Pulnix TM-7EX Manuel Page 21