Pulnix TM-7EX Manuel télécharger pdf (Page 39)

3 Cognex MVS-8100C Hardware

Cognex MVS-8100C Hardware Manual 39

The pinout for camera ports 1 and 3 is shown in Table 14.

The HD-15F connector used for all four camera ports is equivalent to Amp part number

748390-5. The jack screw size for connecting cables is #4-40.

Camera Port Expansion Panel

Figure 4 on page 13 shows the expansion panel that carries the camera 2 and 3 signals

to the PC’s back panel. When installing the expansion panel, note that the 40-pin ribbon

cable straddles both J12 and J5 connectors on the MVS-8100C, and that the red edge

of the ribbon cable must align with pin 1 of the J12 connector.

Signal when jumpered for

color camera

Signal when jumpered for

monochrome camera

1 Video (Red) No connect

2 Video (Green) Video (monochrome)

3 Video (Blue) Rapid reset line out

4 +12 VDC, camera +12 VDC, camera

5 GND (+12V return) GND (+12V return)

6 GND, video No connect

7 GND, video GND, video

8 GND, video No connect

9 +12 VDC, camera +12 VDC, camera

10 GND (+12V return) GND (+12V return)

11 Shield Shield

12 HDRIVE Ground HDRIVE Ground

13 HDRIVE Signal out or CSYNC in

(determined by jumpers J8 and J13)

HDRIVE Signal

14 VDRIVE Signal VDRIVE Signal

15 VDRIVE Ground VDRIVE Ground

Table 14. Pinout for camera ports 1 and 3

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 55 56

Pas de commentaire

Pulnix TM-7EX Manuel Page 39